Car Tales

The torque specs are as follows:
Cylinder head bolts: 32ft/lbs, start at the center and work your out to the end, do this to both heads
Tighten each headbolt 90 degrees more in the same sequence
Tighten them again 90 degrees more in the same sequence, that's it.
The cam bearing caps:
Tighten to 10ft/lbs
The intake manifold bolts:
Around 15ft/lbs

You're driving a diesel single cylinder head engine. Engine head torque has to be done in specific order and stages if not can warp head or break bolts. Suggest you get torque sequence and torque specs from your Toyota dealer, they can give you correct answer. Don't trust answers on here, if you choose wrong specs. could end up messing up head.